Kolink Citadel Mesh ATX ARGB Midi Tower - black

• Suitable for mainboards up to the E-ATX form factor
• Space for graphics cards up to 385 mm, CPU coolers up to 180 mm and power supplies up to 200 mm
• Possible to mount a 420 mm radiator in the front and a 360 mm radiator on the top
• I/O panel with one USB-C, two USB 3.0, and one USB 2.0 ports as well as 2x Audio In- and Out-Put
• Large mesh front for good airflow
• With a total of four pre-installed 120mm PWM fans with ARGB LEDs
• Includes controller for lighting and PWM adjustment via IR remote control

The Kolink Citadel Mesh ATX ARGB Midi-Tower in detail

It is your build, so protect it with the Kolink Citadel Mesh ATX ARGB Midi-Tower. This case has optimal airflow, and is great for those who want to display their high-end gaming hardware. The extensive mesh front sets a new base for your favoured RGB gaming setup, together with four pre-installed 120 mm fans. Due to ARGB every LED itself can be controlled via the included controller and IR remote, which encourage individual stunning looks. Enjoy it every time you look at it thanks to the tempered glass as side panel.

Space is used creatively

The interior is completely black. The case utilises every possibility to organize your hardware at its best, for example, a dedicated PSU shroud contributes to a clean look. Below sits the disk cage which supports two 3.5 or 2.5 inch HDDs or SSDs. In addition, you can mount two 2.5 inch SSDs behind the mainboard tray.

Together with the PSU shroud, the Kolink Citadel Mesh ATX ARGB midi tower offers numerous openings for cable management. The standard ATX power supply sits on top of a removable dust filter.

Graphics cards only fit up to a length of 385 mm. CPU coolers may have a maximum height of 180 millimetres. On the other hand, Mainboards reach up to the E-ATX format.

There are 7+3 PCI slots. Accordingly, graphics cards with a height of up to three slots can be installed vertically. The I/O panel on top offers two USB 3.0, one USB 2.0, and one USB-C ports, as well as an audio connection.

Airflow meets performance

In the Kolink Citadel ARGB midi tower are four 120 mm fans from Kolink′s Umbra series pre-installed. Three are located in the front, while one sits upon the back. The fans offer a good performance and can be installed with a 4-pin connector to the mainboard. Don′t worry, the pre-installed RGB controller acts as a PWM hub too, so six fans can additionally be used and also controlled via remote. The pulse width modulation benefits you: It controls the speed of the fans automatically, which adapts the cooling to the required performance.

Cool as you please

The front consists largely of Mesh and contributes significantly to the good airflow of the case. You can install up to seven 120 mm fans in the Kolink Citadel Mesh Midi Tower.

But don′t stick to the fans: Alternatively replace them with three 140 mm fans on the front, two in the top, or one in the rear. You can even implement a water cooling system: Install radiators up to 420 mm in the front and a maximum length of 360 mm in the top.

On the top there is a magnetic dust filter over the honeycomb mesh. It also prevents dust from entering your system.